ISSN 0253-2778

CN 34-1054/N

Open AccessOpen Access JUSTC Original Paper

Study on pulse transmission delay of Pockels Cell feedforward driving source applied to photon modulation

Cite this:
https://doi.org/10.3969/j.issn.0253-2778.2014.04.004
  • Received Date: 18 October 2013
  • Accepted Date: 27 December 2013
  • Rev Recd Date: 27 December 2013
  • Publish Date: 30 April 2014
  • A Pockels Cell feedforward driving source based on DC modulation was proposed, which was applied to photon modulation. Aiming at the scattering effect of distribution parameters on wave propagation in circuit, an equivalent model circuit was built to simulate the pulse wave transmission in circuit and the influence of the scattering effect of distributed parameters on the triggered flow of the power switching device was analyzed. It was found that the scattering effect of distributed parameters on the switching drive signal resulted in a slower front edge of the drive pulse, which prolonged the triggered flow delay of the power switching device and increased the rising edge of the power pulse, thus increasing the delay time of pulse transmission. Some methods, including driving circuit improvement, circuit wiring optimization, and augment of an LC network matching circuit, were adopted to improve drive pulse transmission time delay. Experiment results indicate the pulse transmission delay of the improved circuit dropped remarkably from 300 ns to 100 ns in comparison with the original circuit.
    A Pockels Cell feedforward driving source based on DC modulation was proposed, which was applied to photon modulation. Aiming at the scattering effect of distribution parameters on wave propagation in circuit, an equivalent model circuit was built to simulate the pulse wave transmission in circuit and the influence of the scattering effect of distributed parameters on the triggered flow of the power switching device was analyzed. It was found that the scattering effect of distributed parameters on the switching drive signal resulted in a slower front edge of the drive pulse, which prolonged the triggered flow delay of the power switching device and increased the rising edge of the power pulse, thus increasing the delay time of pulse transmission. Some methods, including driving circuit improvement, circuit wiring optimization, and augment of an LC network matching circuit, were adopted to improve drive pulse transmission time delay. Experiment results indicate the pulse transmission delay of the improved circuit dropped remarkably from 300 ns to 100 ns in comparison with the original circuit.
  • loading
  • [1]
    Lu Jingping, Zheng Kuixing, Zhang Xiongjun, et al. Study on large aperture plasma-electrode pockels cell electro-optical switch[J]. High Power Laser&Particle Beams, 2000, 12(S1): 137-140.
    鲁敬平, 郑奎兴, 张雄军, 等. 大口径等离子体电极普克尔盒电光开关研究[J]. 强激光与粒子束, 2000, 12(S1): 137-140.
    [2]
    Yuan Xuelin, Ding Zhenjie, Yu Jianguo, et al. Research on high-stability pulse based on avalanche transistor Marx circuit[J]. High Power Laser and Particle Beams, 2010, 22(4):757-760.
    袁雪林, 丁臻捷, 俞建国, 等. 基于雪崩管Marx电路的高稳定度脉冲技术[J]. 强激光与粒子束, 2010, 22(4): 757-760.
    [3]
    Yang Qing, Huo Yujing, He Shufang. Development of a high-voltage fast pulsed source for two-stage cascaded electro-optic switch[J]. Infrared and Laser Engineering, 2013, 43(1): 79-84.
    杨清, 霍玉晶, 何淑芳. 两级串联式电光开关高压快脉冲源的研制[J]. 激光与红外, 2013, 43(1): 79-84.
    [4]
    Zhang Wei, Liu Baiyu, Ruan Chi, et al. High-repetition frequency high-voltage narrow pulse source achieved by frequency superposition[J]. Infrared and Laser Engineering, 2011, 40(7): 1 257-1 262.
    张伟, 刘百玉, 阮驰, 等. 利用频率叠加的方法实现高重频高压窄脉冲源[J]. 红外与激光工程, 2011, 40(7): 1 257-1 262.
    [5]
    Xu Yucun, Wang Xiangqi, Feng Deren, et.al. Fast solid modulator technique based on MOSFET with 6×10 cells[J]. High Power Laser&Particle Beams, 2008, 20(6): 1 043-1 047.
    徐玉存,王相綦, 冯德仁, 等. 基于MOSFET的6×10单元快速固态调制器[J]. 强激光与粒子束, 2008, 20(6): 1 043-1 047.
    [6]
    Wang Xiangqi, Feng Deren, He Ning, et.al. Test principle research for solid-state modulator technique with sub-micro second based on MOSFETS[J]. Journal of University of Science and Technology of China, 2007, 37(1): 99-103.
    王相綦, 冯德仁, 何宁, 等. 基于MOSFET亚微秒固态调制器技术的试验研究[J]. 中国科技大学学报, 2007, 3(1)7: 99-103.
    [7]
    赵智大. 高电压技术[M]. 北京: 中国电力出版社, 2006.
    [8]
    Cheng Zongxiang, Shu Lin, Liu Yanfei, et al. Analysis of MOSFET loss model based on current source driver[J]. Electric Power Automation Equipment, 2010, 30(10): 50-53.
    陈宗祥,束林,刘雁飞, 等. 基于电流源驱动的MOSFET管损耗模型及其分析[J]. 电力自动化设备, 2010, 30(10): 50-53.
    [9]
    Fu Jizhen, Zhang Zhiliang, Liu Yanfei. A new high efficiency current source driver with Bipolar gate voltage[J]. IEEE Transactions on Power Electronics, 2012, 27(2): 985-997.
    [10]
    Merensky L M, Kardo-Sysoev A F, Flerov A N, et al. A low-jitter 1.8kV 100-ps rise-time 50-kHz repetition-rate pulsed-power generator[J]. IEEE Transactions on Plasma Science, 2009, 37(09): 1 855-1 862.
  • 加载中

Catalog

    [1]
    Lu Jingping, Zheng Kuixing, Zhang Xiongjun, et al. Study on large aperture plasma-electrode pockels cell electro-optical switch[J]. High Power Laser&Particle Beams, 2000, 12(S1): 137-140.
    鲁敬平, 郑奎兴, 张雄军, 等. 大口径等离子体电极普克尔盒电光开关研究[J]. 强激光与粒子束, 2000, 12(S1): 137-140.
    [2]
    Yuan Xuelin, Ding Zhenjie, Yu Jianguo, et al. Research on high-stability pulse based on avalanche transistor Marx circuit[J]. High Power Laser and Particle Beams, 2010, 22(4):757-760.
    袁雪林, 丁臻捷, 俞建国, 等. 基于雪崩管Marx电路的高稳定度脉冲技术[J]. 强激光与粒子束, 2010, 22(4): 757-760.
    [3]
    Yang Qing, Huo Yujing, He Shufang. Development of a high-voltage fast pulsed source for two-stage cascaded electro-optic switch[J]. Infrared and Laser Engineering, 2013, 43(1): 79-84.
    杨清, 霍玉晶, 何淑芳. 两级串联式电光开关高压快脉冲源的研制[J]. 激光与红外, 2013, 43(1): 79-84.
    [4]
    Zhang Wei, Liu Baiyu, Ruan Chi, et al. High-repetition frequency high-voltage narrow pulse source achieved by frequency superposition[J]. Infrared and Laser Engineering, 2011, 40(7): 1 257-1 262.
    张伟, 刘百玉, 阮驰, 等. 利用频率叠加的方法实现高重频高压窄脉冲源[J]. 红外与激光工程, 2011, 40(7): 1 257-1 262.
    [5]
    Xu Yucun, Wang Xiangqi, Feng Deren, et.al. Fast solid modulator technique based on MOSFET with 6×10 cells[J]. High Power Laser&Particle Beams, 2008, 20(6): 1 043-1 047.
    徐玉存,王相綦, 冯德仁, 等. 基于MOSFET的6×10单元快速固态调制器[J]. 强激光与粒子束, 2008, 20(6): 1 043-1 047.
    [6]
    Wang Xiangqi, Feng Deren, He Ning, et.al. Test principle research for solid-state modulator technique with sub-micro second based on MOSFETS[J]. Journal of University of Science and Technology of China, 2007, 37(1): 99-103.
    王相綦, 冯德仁, 何宁, 等. 基于MOSFET亚微秒固态调制器技术的试验研究[J]. 中国科技大学学报, 2007, 3(1)7: 99-103.
    [7]
    赵智大. 高电压技术[M]. 北京: 中国电力出版社, 2006.
    [8]
    Cheng Zongxiang, Shu Lin, Liu Yanfei, et al. Analysis of MOSFET loss model based on current source driver[J]. Electric Power Automation Equipment, 2010, 30(10): 50-53.
    陈宗祥,束林,刘雁飞, 等. 基于电流源驱动的MOSFET管损耗模型及其分析[J]. 电力自动化设备, 2010, 30(10): 50-53.
    [9]
    Fu Jizhen, Zhang Zhiliang, Liu Yanfei. A new high efficiency current source driver with Bipolar gate voltage[J]. IEEE Transactions on Power Electronics, 2012, 27(2): 985-997.
    [10]
    Merensky L M, Kardo-Sysoev A F, Flerov A N, et al. A low-jitter 1.8kV 100-ps rise-time 50-kHz repetition-rate pulsed-power generator[J]. IEEE Transactions on Plasma Science, 2009, 37(09): 1 855-1 862.

    /

    DownLoad:  Full-Size Img  PowerPoint
    Return
    Return